All pipework is available in aluminised or stainless steel. Where applicable, we have taken measurements of each part (see below for technical drawings).
All dimensions are available by searching through our custom parts catalogue and by clicking on the part required. 

 Bends 

• Measurement A = Distance between inner edges in mm.
• Measurement B = Vertical distance between underside of bend and the ground in mm.
• Measurement C = Distance of outermost edge of each bend to beginning of curve in mm.

 Straight Lengths 

• Measurement A = Horizontal overall length in mm.

 Over-Axle Bends 

• Measurement A = Overall length in mm.
• Measurement B = Length between beginning of inner curve in mm.
• Measurement C = Vertical distance between underside of bend and the ground in mm.
• Measurement D = Width of stubs before curve begins in mm.
• Measurement E = Length of outermost striaght edge (between curves) in mm.

 Compensators 

• Measurement A = If standing, overall height in mm.
• Measurement B = If standing, overall width in mm.
• Measurement C = If standing, length of end stubs in mm.
• Measurement D = If standing, overall depth in mm.

 Double Ended Sleeves 

• Measurement A = Horizontal overall length in mm.

 Stepped Sleeves 

• Measurement A = Overall length in mm.
• Measurement B = Length of first and smallest step in mm.
• Measurement C = Length of middle step in mm.
• Measurement D = Length of largest step in mm.
• Measurement E = Diameter of largest step in mm.
• Measurement F = Diameter of smallest step in mm.
• Measurement D = Diameter of middle step in mm.

 Y-pieces 

• Measurement A = Overall length in mm.
• Measurement B = Outer length of branch to single end stub in mm.
• Measurement C = Inner length of branch to 'Y' join in mm.
• Measurement D = Diameter of individual branch in mm.
• Measurement E = Overall width of 'Y' in mm.
• Measurement F = Diameter of single end stub in mm.

 Decibel Insert 2" 

• Measurement A = Overall length in mm.
• Measurement B = Length of larger diameter section in mm.
• Measurement C = Diameter of smaller section in mm.
• Measurement D = Diameter of larger section in mm.

 Decibel Insert 2.5" 

• Measurement A = Overall length in mm.
• Measurement B = Length of first section in mm.
• Measurement C = Length of second section in mm.
• Measurement D = Length of third section in mm.
• Measurement E = Diameter of first section in mm.
• Measurement F = Diameter of third section in mm.

 Decibel Insert 3" 

• Measurement A = Overall length in mm.
• Measurement B = Length of larger diameter section in mm.
• Measurement C = Diameter of smaller section in mm.
• Measurement D = Diameter of larger section in mm.