All silencers are available in aluminised or stainless steel. Where applicable, we have taken measurements of each part (see below for technical drawings).

All dimensions are available by searching through our custom parts catalogue and by clicking on the part required.

It does not matter which way round the silencers are fitted. There is no inflow or outflow end.

Jetex silencers can be separated into two categories 

• Category A  One pipe in, one pipe out. Almost all of our silencers (whether round or oval) have a single perforated tube through the middle.
  
• Category B  One pipe in, two pipes out. These have recently been added to our range of custom parts. They are ideal for running two exhausts side by side (for performance or styling reasons).
  

 Silencers 

• Measurement A = Length of silencer (excluding end stubs) in mm.
• Measurement B = Width (or diameter if round) of silencer in mm.
• Measurement C = Length of end stubs in mm.
• Measurement D = Height of silencer in mm.

 Silencers (splitter) 

• Measurement A = Length of silencer (excluding end stubs) in mm.
• Measurement B = Width of silencer in mm.
• Measurement C = Length of end stubs in mm.
• Measurement D = Height of silencer in mm.
• Measurement E = Diameter of split end stubs in mm.